WIRING
After determining the number and/or power of the electricity supplies, no more than 100 LEDs should be wired on loops in parallel.
To connect these loops in parallel to the 24V supply cables (+ and-), useelectricallyinsulatedconnectorstoavoidanyshort-circuits (cf. connector accessories) or make a connection with solder and heat-shrinkable tubing.
ADVICE
The choice of back material for reflecting the light is vital in obtaining maximum performance in a backlit application. A mat or satin finish is the best diffuser. If you have a bright support (glass, gloss paint, composite, etc.) you may either position a sand-type adhesive or sand all or part of the reflecting surface.
As with any sign, once it has been assembled we advise you to perform an aging test lasting at least 48 h to check that it has been properly assembled and connected and that the LEDs have not suffered any damage in the process.
