WIRING
After determining the number and/or power of the electricity supplies, no more than 60 LEDs should be wired on loops in parallel. To connect these loops in parallel to the 24V supply cables (+ and -), use electrically insulated connectors to avoid any short-circuits (cf. connector accessories) or make a connection with solder and heat-shrinkable tubing.
IMPORTANT REMINDER:
Cross-section of carrier cable connecting loops:
• 1,5 mm2 when the power supply is less than 2 m from the sign
• 2,5 mm2 when the power supply is less than 2 m from the sign
ADVICE
As with any sign, once it has been assembled we advise you to perform an aging test lasting at least 48 h to check that it has been properly assembled and connected and that the LEDs have not suffered any damage in the process.
