Wiring
After determining the number and/or power of the electricity supplies, no more than 200 LEDs should be wired on loops in parallel.
To connect these loops in parallel to the 24V supply cables (+ and -), use electrically insulated connectors to avoid any short-circuit (cf. connector accessories) or make a connection with solder and heat-shrinkable tubing.
Important reminder
Cross-section of carrier cable connecting loops:
• 1,5 mm2 when the power supply is less than 2 m from the sign
• 2,5 mm2 when the power supply is more than 2 m from the sign
Advices
As with any sign, once it has been assembled we advise you to perform an aging test at least for 48 h to check that it has been properly assembled and connected and that the LEDs have not suffered any damage in the process.
