Wiring
Unlike other products in the range, and in view of their small size, the only way to connect each part of the Domino Flex (both versions) after cutting is to solder the + and – ends indicated on the printed circuit, using a suitable solder. (see photo)
Warning: do not exceed the 5 metre length, i.e. 420 LEDs. After having determined the number and/or power of the electricity supply units, the parallel loop wiring must comprise no more than 420 LEDs (i.e. 5 metres in length).
To adapt the length of the Flex to your letter or logo, you can either cut 6-LED units along the mark (see photo) or fold the printed circuit and silicone sheath back on itself.
The only parts of the Flex that can be folded back on themselves are those that do not contain electronic components such as the LEDs or resistances (see the sketch indicating possible folding areas).
Carrying out these operations calls for precision and requires the use of appropriate tools. We therefore recommend using a standard reference to measure the Domino Flex lengths required to illuminate your letters. This avoids excessive handling of the Domino Flex, which might otherwise damage the internal connections.
To ensure water tightness after cutting the silicone sheath, it is advisable to use translucent glue; this will fill and thus seal the sheath. This must be done on both ends when a Flex is used outdoors.
